DEVIMAT™ INSTALLATION

HOW TO INSTALL YOUR DEVIMAT

You can do most of the job yourself, but Connection to the power supply may ONLY be carried out by an qualified electrician

Welcome...
to our step-by-step guide to the installation of the Devimat self-adhesive underfloor heating mat.

It's your choice. You can view the video now online (requires Flash 8+ Plugin), download it for later, or read our step-by-step instructions below.

Download Video
MPEG Format (~70MB).

Step by Step Instructions

Step 1
Measure the room and draw a sketch to help you calculate which DEVI package you will need. Then sketch in the position of the devimat heating cable mat.

Step 2
Mark the positioning of the toilet before you remove it. This helps you avoid placing the toilet on top of the mat - and prevents you from piercing it with screws.

Step 3
Cut a channel approx. 10 mm deep and wide in the wall and the floor, from the thermostat and about 1 m out into the floor. Glue the flex pipe for the sensor into this channel, and seal the end of the pipe with a piece of tape.

Step 4
Clean the floor thoroughly, removing all dirt and soap residue, then lay out the self-adhesive cable mat. The floor surface must be primed if you are not laying the mat on existing tiles.

Step 5
Clip through the grey netting to turn the mat over - but make sure that you do not cut through the red cable!

Step 6
Turn the mat and position it as required. The self-adhesive effect can withstand 10-20 adjustments, so you can move the mat several times until you are satisfied with the result.

Step 7
Once you have positioned the cable mat, you can - depending on the new floor surface - encapsulate it using selflevelling screed or cover it with a thin layer of tile adhesive.